Jointer

When to use:

Jointers are used to make sure your board is true after using the planer. This is important to make sure your end result will be square and fit together properly.

Safety: 

1. Boards must be no shorter than 12” to use this tool
2. A  push block must be used 100% of the time when operating this tool
3. Keep fingers 3” or more away from the cutting blade 
   

Procedure:

1. Attach dust collection 
2. Adjust depth of the cut
3. Adjust fence for board width and angle
4. Turn on dust collection 
5. Place “Wide” side of the board on the jointer, run it through until it is true
6. Run the just jointed face on the fence to joint the short edge of the board
7. Turn tool and dust collection off
8. Clean up tool and surrounding space